HY-LINE truecon Router Handbuch Seite 57
HY-LINE Systems GmbH
Inselkammerstr. 10 82008 Unterhaching systems(at)hy-line.de www.hy-line.de/systems
57
Software-Reset to factory defaults
(available on Router hardware newer January 2009)
1. Turn off router from power supply
2. Set umper 1 to ON position (Jumper 1 is located on the router side inside the case)
3. Turn ON router, reset is finished after 2 minutes when the leds starts flashing permanently
4. Turn off router from power supply
5. Set jumper 1 to OFF position
6. Reset is finished