Hybernite Superday ROC 2300, Instructions For Use Manual

6. Operating Conditions

Operating Temperature:  

5°C – 30°C (41°F – 86°F)

Relative humidity:  

5% – 95%

7. Storage and Transport Conditions

Storage temperature  

- 20 °C (-4°F) ... + 60 °C (120°F)

Relative humidity    

5 % ... 95 %

Storage conditions   

The Hybernite System should be transported and stored in the original 

packaging and protected from dust and exposure to direct sunlight.

8. Frequently Asked Questions

Question:  

What happens if I connect the mask-end cuff to the humidifier and the humidifier-
end cuff to the mask? 

Answer:  

The Hybernite System works exactly as if the tube was connected correctly (mask 
cuff to mask and humidifier cuff to humidifier). However, for safety reasons and to 
ensure maximum comfort, connect the tube as described in the user’s manual.

Question:  

Can I use the tube without a power supply?

Answer:  

Yes, the tube will then works like a standard tube for respiratory therapy devices. 
Respiratory air condensation can however form in the tube.

Question:  

When do I have to replace the tube?

Answer:  

The tube must not be used for longer than 12 months. If the tube is damaged or a 
leak or malfunction occurs, then the tube should be replaced immediately.

Question:  

Which humidifier or flow generator can I use the Hybernite System with?

Answer:  

The cuffs of the Hybernite have the same diameter as standard tubes for respiratory 
therapy systems. Therefore, you can use the tube with all humidifiers that are 
intended for the connection of a standard tube: examples: ResMed HumidAire 2i; 
ResMed HumidAire 3i; ResMed H4i; ResMed H5i; Philips Respironics System One 
humidifier; Respironics M-series humidifier; Respironics Legacy Series humidifiers; 
Breas HA20 Humidifier; Devilbiss Heated Humidification systems; Weinmann 
SOMNOcomfort 2; Weinmann SOMNOsoft 2; Weinmann SOMNObalance; 
Hoffrichter Point2; Sefam Dreamstar; Sefam Sandman; Apex; BMC; etc

Question:  

How do I get maximum comfort from using the Hybernite Rainout Control System?

Answer:  

The maximum comfort will be different for every patient. The patent is advised to 
change the settings of the humidifier to find the zone of optimal comfort. It can 
be advised to increase the settings of the humidifier to the mid or top third of the 
range (e.g. setting 3, 4 or 5 if the range is from 1 to 5 or settings 4, 5 or 6 if the 
range is from 1 to 6). 

9. Product Specifications

    
Hybernite HBT 300 Heated Breathing Tubing
Length 

1.83 m

Internal Diameter 

19 mm

Flow resistance 

60 l∙min

-1

≤

 0.1 kPa

Tubing Compliance Standards   

ISO 5367:2000

ISO 8185:2007

Water resistance 

IPx3 

Electrical Safety Standard 

EN IEC 60601-1

Type B Applied Part (   )