USER MANUAL - ALTIUM15 /12,
2000W SELF-POWERED FULL RANGE SPEAKER
PAGE 7
PAGE 6
2: POWERCON IN CONNECTOR
5: INPUT CONNECTOR
1: POWERCON IN CONNECTOR
6: INPUT LOOP THROUGH
PIN-OUT CONFIGURATION AS A MONO BALANCED INPUT
PIN-OUT CONFIGURATION AS A STEREO UNBALANCED INPUT
4: FUSE HOLDER
3: POWERCON OUT CONNECTOR
Main power switch, switching the speaker ON or OFF. Once the speaker is switched ON, the
LCD screen will illuminate.
Mains 220 - 240Vac Input connector.
Speaker Input.
Speaker Input.
Pin 1 – Ground
Pin 1 – Ground
Pin 1 – Ground
Pin 3 – Inverting (Cold)
Pin 3 – Left Input
Pin 3 – Inverting (Cold)
Pin 2 – Non-Inverting (Hot)
Pin 2 – Right Input
Pin 2 – Non-Inverting (Hot)
It is recommended that should the fuse be blown, take the speaker for testing to your
nearest authorised service centre. Usually when a fuse has blown, it indicates that there are
damaged components within the circuitry of the speaker. By changing the fuse and restarting
the speaker, it may cause further damage to components.
DO NOT
modify the cable in any way.
Do not load (Daisy Chain) more than 3 cabinets from the same mains outlet. Overloading the
power source may cause the line circuit breaker to activate and in extreme cases could be a
fire hazard.
Only use the cable supplied with this speaker to power up the unit (Powercon – 3 Pin Mains
South African plug).
The XLR input female connector can be configured as a mono balanced input or a stereo
unbalanced input. To select between the two input modes, the balanced / Unbalanced switch
must be activated within the software via the encoder or app.
The XLR Input Female connector can be configured as a Mono Balanced input or a Stereo
Unbalanced input. To select between the two input modes, the Balanced / Unbalanced switch
must be activated within the software via the encoder or app.
Mains 220 - 240Vac loop through Output connector, allowing multiple Altium15/
Altium12 speakers to be powered by the same mains outlet.
Inspect the cable before use and should any sign of damage be visible, replace the cable with
the exact same, available from your nearest authorised retailer.
Only use Powercon Output – Powercon Input cables to connect multiple speaker cabinets.
3 Core cable (Live, Neutral and Earth), min. 1mm diameter / core.
DO NOT
attempt to bypass the fuse in any manner by bridging the fuse with solid
conductor.
DO NOT
replace the fuse with an incorrect value fuse. Only replace the fuse with
the exact fuse rating as printed on the back panel.
PAGE 7
PAGE 6
