Hybrid Systems JSC
Users Manual
Page 3 of 8
GSM 108 Gate
Instructions to the rear appearance of GSM 108 Gate
The Rear Appearance of GSM 108 Gate
Ports
Power port
—connect to power adapter
Phone port
—connect to a phone
Antenna port
—connect to antenna
Installation and Setup
Installing the SIM Card
Proceed as follows:
1.
Slide back the SIM door and lift it up
2.
Slide the SIM card into the SIM door making sure that the clipped corner of the
SIM card lines up with the clipped corner of the SIM holder
3.
Close the SIM door
4.
Slide the SIM door to lock the SIM card in place
Setting up the Terminal
The Condition for Installation
The terminal asks for 220V AV power supply. It must be installed in the area
where the GSM network can cover. The strength of the signal can affect the quality of
voice direct.
The Installation for Connect to Ordinary Telephone
Screw off the screws that are on the back of the terminal and pull out the
corresponding circuit board. Install SIM card for every circuit board and install the
circuit board in place, and then tighten the screws.
Install antenna. In order to ensure the quality of voice, antenna must be put beyond
1.5m from the telephone and terminal.
One end of the telephone line connects to the “Phone” port of the terminal, the
other end connects to telephone.