4
Location and Installation
NOTE: Before beginning installation, consult proper local authorities regarding local codes governing all such applications and
installations.
DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE. Your furnace must be placed on a non-
combustible floor. Position the furnace as close to the chimney as possible. Air for combustion must be provided into the room where the
furnace is located. Allow air free access to the furnace for combustion and ventilation.
Garage installs are not recommended due to National
F
ire
C
odes. Consult with your local code and insurance company.
When installing an indoor furnace, the heat plenum coming off the top of the appliance can only go up or horizontal to connect into the
main supply duct. Never run the plenum down as this will create a heat buildup in the furnace causing the blower to short cycle and
damage the blower motor and will not be covered under warranty. This is not a down draft fur
n
ance and not to be installed as one. If you
do not have a basement and the plenum cannot be put in the ceiling, then we recommend our Fire Chief
outdoor
furnace
model FC1900
.
RECOMMENDATION: Purchase Chimfex™ Dry Chemical Chimney Fire Extinguisher. These are readily available at most stove shops
and hardware stores. Smoke detectors should be installed on all levels of your home. Having a fire extinguisher in the furnace room or
area is strongly recommended.
Assembly of Unit
Please review the parts list and diagrams contained on pages 15 - 17 of this manual.
DOUBLE CHECK TO MAKE SURE YOU HAVE RECEIVED ALL THE REQUIRED
COMPONENTS. IF YOU FIND THAT THERE IS A PART MISSING, CALL
1-800-875-4788
IMMEDIATELY.
PLEASE DO NOT GO BACK TO THE
DEALER.
THE
DEALER DOES NOT CARRY REPLACEMENT PARTS.
RETURN AIR
DUCT
SUPPLY
DUCT
BACK
DRAFT
DAMPERS
OPEN/CLOSE
RETURN
DAMPERS
- 3 PLACES
