2.4
PLC 100 CONTROL SYSTEMS
NOTE: This instruction manual is applicable to the H-18/22 SV equipped with a MITSUBISHI PLC.
OPERATION OVERVIEW
The PLC is a programmable logic controller which allows the operator to run the machine in both manual and automatic
modes.
In manual mode, all functions can be operated by using a combination of selector switches on the control console and
the PLC function buttons. Also the operator has the ability to execute a single cut utilizing a preprogrammed “Single Part
Cycle”.
In automatic mode, the PLC has the capacity to program and store 99 jobs. Designated job numbers can be programmed
for quantity required (maximum of 999 pieces) and lengths from 0.1” to 220” (5588mm).
Jobs can be run individually or in a QUEUE which allows a maximum of 5 jobs to run consecutively and the queue can be
repeated automatically as well up to 99 times.
All machine operators should be familiar with the entire operation instructions prior to operating the machine.
NOTE: If an emergency situation arises during any operation, use the large red mushroom “STOP” button located on the
control panel to shut down the machine. To operate the machine, the “STOP” button must be pulled out.
DISPLAY WINDOW
F3
F4
ENTER KEY
NAVIGATION
KEYS
F5
F2
Summary of Contents for H18 A
