OffLine Separator - OLS
HYDAC Filtertechnik GmbH
en
Page 16
BEWA OLS 3329742a en.doc
2006-11-29
12 Maintenance
12.1
First month or 700 hours of operation
•
Tighten up all cutting ring fittings, screws and bolts.
12.2
First 6 months or 4400 hours of operation
After the first 6 months or 4400 hours operation the clutch must be inspected. Remove
inspection cover on clutch housing. If wear is found at the clutchparts, the reason must be
found and eliminated before the OffLine Separator OLS is restarted. See instruction book
from manufacturer of the clutch for further details.
12.3 Daily
•
Inspect the OffLine Separator OLS for leaks.
•
Observe the clogging indicator. If the backpressure are above 2,5 bar, the Filter
Element must be replaced.
12.4 Weekly
•
Observe that the motor-/pumpgroup are running without extreme noise and
vibrations.
12.5
Monthly or every 700 hours operation
•
Open bleed plug at top of the housing until oil appears.
•
Carefully open the drain valve slightly until oil appears.
12.6
12 months or every 8800 hours operation
•
Replace the Filter Element and o-ring.
•
Clean all parts in Separation chamber.
•
Inspect bearings in motor, replace if needed.
•
Inspect bearings and shaftseal in pump, replace if needed.
•
Inspect clutch for wear and replace if needed.
•
Inspect hoses for damages and crack formations, replace if needed.
•
Tighten up all cutting ring fittings, screws, bolts and electric terminals.
