Measured values
HMG 4000
Edition 2016-03-08 - V01 R04
[44]
Part No.: 669950
Configuring CAN message
In the following you can activate and
then configure up to 28 CAN
messages (sub-channels)
individually. These messages are
then evaluated by the HMG like
"normal" measurement channels
(measured values).
If you selected and activated a
(CAN bus channel Kn), the adjacent
configuration window will open.
Adjust all of the necessary settings,
one after the other according to the
bus messages, which need to be
evaluated and displayed as a
measured value.
Message type
The HMG 4000 can evaluate the
following message types:
General
J1939 Message
CANopen PDO
CANopen SDO
Depending on the selected message
type, the required
settings/configurations vary as
described in the following.