Recordings
HMG 4000
Edition 2016-03-08 - V01 R04
[60]
Part No.: 669950
8.2.3 Event-controlled recording
For an event-controlled recording you
must specify the following settings:
Measurement channel settings
Under this menu point you can set which measurement channels should be added
to the recording and which channels are to be "
switched off
" for it.
Measurement rate
Under this menu point you can set the time interval that the HMG 4000 reads in a
measured value from the "
active
" sensors and stores it in the internal memory..
The measured values according to the set measurement rate are saved
independent from the signal update time of the connected sensors.
This means that, for example, with a preset measurement rate of 1 ms and a
signal update time of 10 ms, the measured value will be saved 10 times before
the signal at the input changes.
Maximum recording duration
Under this menu point, you can select a recording length of 10 seconds, staggered
for up to 28 days.
Zoom area
With the "zoomed area", an additional display area can be created during the
recording in the graphic mode.In other words, with the
Magnifier
setting, the x-axis
is scaled to the time span preset in this menu point (5 seconds / 10 seconds / ...).
Storage settings
Under this menu point you can specify the storage type, folder and file name for the
corresponding recording.
Event settings
Under this menu point, you can specify the settings for the event control. (start
condition / end condition / trigger events /
distribution of measured values / action after end of the recording)
