HYDAC FILTER SYSTEMS GMBH
Performing Maintenance | 8
BeWa MFU-10P 4391553c en-us web
97 / 120
4.
Remove the ContaminationSensor in an upwards
direction and observe the two O-rings (521). Remove
the O-rings (521).
5.
Use the screwdriver to rotate the protective screen (531)
out in a counterclockwise direction.
6.
Clean the protective screen (531) by blowing it out with
compressed air or replace the protective screen (531).
O
The disassembly is complete.
Proceed as follows to install:
7.
Use the screwdriver to screw the protective screen (531)
up to the stop in clockwise direction into the
ContaminationSensor.
8.
Check the O-rings (521) for damage. If necessary,
replace them.
9.
Insert the O-rings (521) in the ContaminationSensor.
10.
Set the ContaminationSensor on the MFU and screw it
in with the screws (550) in a clockwise direction and
tighten the screws with a tightening torque of 10 Nm.
11.
Connect the male connector (561) to the supply voltage
with the ContaminationSensor. Open it by rotating it
clockwise.
O
The changing of the protective screen is complete.
1
2
3
4
5
6
7
8
9
A
Summary of Contents for MFU-10P9S Series
Page 120: ...www hydac com ...
