5 | Setting up / assembly / integration of the filter unit
HYDAC FILTER SYSTEMS GMBH
40 / 88
BeWa MFU-30E 4073898a en-us web
5 Setting up / assembly / integration of the filter unit
Observe the following notices for mounting the filter unit.
5.1 Mounting/dismounting the push handle
Mount the push handle, included in the scope of delivery, as
per the following figure:
ü
Place the filter unit in standing position on the floor.
1.
Slide the push handle through the hole on the rear side
up to the receiver plate.
2.
Insert the clip pin (112) through the holes on the receiver
plate and the push handle.
3.
Secure the clip pin (112) by turning over the spring clip.
O
The mounting of the push handle is complete.
Dismount the push handle by opening and pulling the clip pin.
1
2
3
4
5
6
7
8
9
A
Summary of Contents for MFU-30E
Page 88: ...www hydac com ...
