ENGLISH
16
temperature.
5. Plug the cable into the mains.
6. Switch on appliance (setting ON/OFF switch on “I“) and select intensity
or programme mode by remote control.
7. Slowly step into the bath.
On/Off switch on the unit
You can
fi
nd the ON/OFF and emergency switch on the reverse side.
„0“
= Appliance is switched off
„I“
= Appliance is ready for operation and can be controlled
by remote control
„II“
* = Emergency control if remote control is not operational.
Appliance runs at medium level. Heater is switched
on.
*ATTENTION!
Appliance switches automatically off after 15 minutes.
This setting can be selected as well if you do not like to use the
remote control. Remote controlled functioning.
Service per remote control
The functions are selected by remote control (Fig. 5). To use the remote
control, point it directly at the infrared detector on the blower. The remote
control is splash resistant. If it falls in the water, take it out immediately and
dry it before using it again.
POWER ON/OFF
For starting the appliance press POWER button. The
appliance runs at lowest intensity.
SPEED
By pressing the SPEED button after that the appliance
changes to medium intensity level. By pressing the
SPEED button again the appliance changes to strong
intensity level. By pressing the SPEED button again
the appliance changes to low intensity, etc.
Fig. 5