HREI
Inst Issue 1: 09.05.16
Installation and Maintenance Instructions.
THESE INSTRUCTIONS MUST BE READ FULLY BEFORE COMMENCING INSTALLATION.
Owner / installer:
The life of this apparatus and its efficiency will be increased if
its use and maintenance is carried out in accordance with these instructions and
current statutory requirements. The installation and initial adjustments should be
carried out by a qualified and competent technician. Hydor Limited should be
consulted before submitting or fitting parts from another manufacturer. It is the
responsibility of the installer to verify that the installation is in accordance with
the following standards and the owner is given the current User’s Manual.
Any modifications to the unit or its installation, even the smallest
modification, change or elimination of security components or pieces that
influence the efficiency or loss of ventilation, will result in the CE Certification
and Hydor’s warranty being cancelled.
1. General
1.1 It is important these Installation and Maintenance Instructions are fully
adhered to.
1.2 Full details of the unit supplied are shown on the product nameplate. If in
doubt about any detail contact Hydor or its agents for clarification.
1.3 All electrical installation must be carried out by a suitably qualified
and competent personnel in accordance with all current statutory
requirements.
1.4 These instructions cover only the Hydor product and do not include the
supply or installation of safety equipment that may be required, e.g.
adequate protection and proper electrical isolation.
1.5 Any declarations made by Hydor about product installation and safety,
are dependent on other equipment being used within installation which
themselves meet the requirements of the Standards and Directives or your
region.
1.6 The heater is designed for use in an ambient temperature of up to
50C and up to 90% relative humidity. The unit is NOT suitable for corrosive
or explosive atmospheres.
HCBI
Indirect Gas Fired Heater
incorrect
correct, minimum height 5mm
