16
7. Connection of Pump-Out Hose:
The pump-out hose is a 50’ section of 3/4” garden hose. (Use of smaller diameter hose may reduce flow.)
•
Remove the cap from the pump-out outlet fitting on the back of the machine.
•
Connect the pump-out hose to the outlet fitting.
•
Place the other end of the hose in a commode or drain connected to the sanitary sewer system.
•
Secure hose end to prevent movement during pumping.
Use defoamer to prevent foam build-up in recovery tank during cleaning and to keep
foam/moisture from entering vacuums.
Use Hydro Filter II inline filter to trap and remove debris from the waste water before it
enters the recovery tank. Excess debris in recovery tank may clog Pump-Out filter. Clean
Filter as needed during use.
Do not turn the Waste Pump switch ON unless pump-out hose is connected and has been
routed to a proper drain.
The Waste Pump uses a float switch and does not start pumping until the water level in the
tank is high enough to lift the float switch. The pump will turn ON & OFF during normal
operation. Pump will be damaged if allowed to run dry.
When ready to begin cleaning, turn the Waste Pump switch to the ON position.
If not using the waste pump-out, the pump-out hose does not need to be connected. When the recovery tank
fills during cleaning, the float assembly in the vacuum inlet filter will rise and will automatically shut off the
vacuum air flow to prevent the recovery tank from overfilling and waste water from getting into the vacuums.
When this occurs:
•
Immediately shut off the vacuum switches.
•
Drain the recovery tank.
o
Turn off the pump switch while draining the tank.
o
Turn pump switch back upon resumption of cleaning.
•
Close the drain valve and turn the vacuum switches back on
when ready to resume cleaning.
If the pump-out or vacuum shutoff is not working properly, refer to
the trouble shooting guide or contact your distributor for advice or
assistance.
Connect the Female
Garden Hose Fitting
end of the Pump-out
Hose to the outlet fitting
on the back of the
recovery tank. Place the
other end of the pump-
out hose in a sanitary
drain.
Float Shutoff Assembly
Draining the Recovery Tank
Summary of Contents for Nautilus Extreme MXE-200
