•
NOT
intended for outdoor use.
•
Do not
operate the unit with a cut or frayed power
cord
•
Do not
unplug the unit by pulling on the cord. Grasp
the plug firmly and pull it out of the wall socket or
power receptacle.
•
Always
use a grounded outlet.
•
Never
operate electrical equipment in standing
water.
•
Never
operate with safety grills removed. Personal
Injury may result!
•
Do not
stick fingers or other objects through the
safety grills.
•
Never
restrict airflow to the unit. This may cause it to
overheat.
•
Never
service or clean this unit while it is plugged in.
•
Never
sit or stand on the unit or use as a shelf.
•
Ensure
that children do not have access to the
equipment. Do not allow children to play with or
near the equipment, or in its airflow.
•
To reduce
risk of fire or electric shock, do not use this
air mover with any solid-state speed control device.
•
Do not
leave device plugged in when not in use.
•
Store
this equipment indoors; do not expose to
harsh weather.
•
Use
only as described in this manual.
•
Use
only Manufacturer’s recommended attachments.
•
Do not
pull or carry by the cord, use the cord as a han-
dle, close doors on the cord, or pull the cord around
sharp edges.
•
Do not
run over cord.
•
Keep
cord and housing away from heated surfaces.
GENERAL SAFETY WARNINGS
OPERATING INSTRUCTIONS
1. Check the machine for any obstructions in the
fan or airflow areas before plugging in the unit or
operation of the unit.
2. Adjust the machine to desired position for
operation by pulling it back to its preset angle
adjustments.
3. Plug the power cord into a GFCI outlet. Do not use
an extension cord in conjunction with the standard
power cord.
4. Push the TEST button on the GFCI Duplex power
outlet. FCI should trip.
• If GFCI trips, push the RESET button to reset
GFCI and proceed with set-up
• If GFCI does not trip, the GFCI Duplex power
outlet should be replaced
5. Plug additional air movers into the GFCI Duplex
Power Outlet as needed. (Amp draw of OmniDry
air mover and the additional air movers or other
accessories plugged in the GFCI Duplex Power
Outlet must not exceed 12 amps.)
6. The OmniDry 2.9 air mover has two power settings.
Press the button to HIGH or LOW, depending on the
desired speed.
CAUTION
•
Do not
handle plug with wet hands.
•
Turn
the unit off before unplugging.
•
Do not
use when you are tired, distracted or under the
influence of drugs, alcohol or medication.
When using any electrical equipment, basic
precautions should always be followed, including
the following:
Hydro-Force Manufacturing • www.hydroforce.com • 800-637-3789
2
