Hydro-Logic
®
Flexi Logger 300Ex
User Manual
22 August 2018
Page 45 of 74
•
Now press the k
eys ‘dh’. You should be prompted for the new sensor
address:
•
Enter the desired address by pressing 1, 2 or 3. On pressing this key, the
Flexi Logger 300 will scan all addresses from 0 to 15. Once it discovers a
sensor, it will set the address of that sensor to the desired address and
stop scanning. You can also set the address as 0 if you want the sensor
to be used for normal 4-20mA output. Non-zero addresses will produce
ad fixed loop current, typically 12mA.
You can now remove the sensor and set the addresses of more, or leave it
connected and configure the logger to use the new sensor address.
Summary of Contents for Hydro-Logic Flexi Logger 300Ex
