42
Page
TEMPERATURE SETTINGS ON THE PCB
(WITHOUT REMOTE CONTROLLER)
There are 2 preset temperatures (120 °F (49 °C) and 140 °F (60 °C)) that you can select from by changing
the DIPswitch se
ttings
on the computer board without the remote controller. See the table below.
When the remote controller is in normal opera
tion,
the set temperature of the remote controller is given
priority over the set temperature of the DIPswitch se
ttin
gs.
Owner's Guide
NOTE:
Only change the switches with dark squares.
The dark squares
indicate the dir
ection
the DIPswitches should be set to.
WARNING
•
DO NOT adjust the upper bank of DIPswitches.
•
Turn o
ff
the power supply to the micro-boiler before changing the DIPswitch
se
ttings.
•
The temperature has been preset at the factory to 120 °F (49 °C).
(Lower bank of DIPswitches)
120 °F (49 °C)
DEFAULT
140 °F (60 °C)
No. 5 : OFF
No. 5 : ON
OFF
ON 1 2 3 4 5 6
OFF
ON 1 2 3 4 5 6
2 3 4 5 6
Computer board
Upper bank of
DIPswitches
Lower bank of
DIPswitches
