1
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS.
READ AND FOLLOW ALL INSTRUCTIONS
1.
DANGER:
To reduce the risk of injury, do not permit children to use this unit unless they are closely supervised at all times.
2. Use this unit only for its intended use as described in this manual. Do not use attachments not recommended by the
manufacturer.
3. Never drop or insert any object into any opening.
4. Do not operate this unit without the cover over the suction fitting.
5. The unit must be connected only to a dedicated electrical supply circuit that is protected by a Ground Fault Circuit
Interrupter (GFCI). The GFCI must be provided by the installer and should be tested on a routine basis by the homeowner.
To test the GFCI push the test button. The GFCI should interrupt power. Push the RESET button. Power should be restored.
If the GFCI fails to operate in this manner there is a ground current flowing, indicating the possibility of an electric shock.
Do not use the tub. Disconnect the power and have the problem corrected by a qualified service representative. Re-test
the GFCI, only when it is operating properly may the whirlpool tub be used.
6. A green colored terminal marked “Ground” is provided on the exterior of the control box. To reduce the risk of electric
shock, connect this terminal to the grounding terminal of your electrical service or supply panel with a conductor equivalent
in size to the circuit conductors supplying this equipment.
IMPORTANT SAFETY INSTRUCTIONS
INSTALLATION INSTRUCTIONS
USER MAINTENANCE INSTRUCTIONS
INSTALLATION INSTRUCTIONS
WARNING: WHEN USING YOUR HYDRO SYSTEMS TUB, BASIC PRECAUTIONS SHOULD BE FOLLOWED, SEE BELOW
•
Read all instructions before proceeding with installation.
•
Inspect the tub before installation. If any damage or defects are found, do not install the tub. If the tub is not the right
size, model or color do not install the tub. Contact tech support at 661-775-0686 or email support@hydrosystem.com
•
INSTALLATION OF A THE METRO COLLECTION BATHTUB MUST MEET ALL APPLICABLE CODES AND REGULATIONS.
IMPORTANT-
All tub and systems are thoroughly tested and inspected at the factory prior to shipment. However, it is possible for
damage to occur during shipment and installation. Such damage is not always readily visible. To maintain the warranty, it
is important to water test the tub, integral overflow and thermal system a minimum of 30 minutes for leaks during rough
inspection before enclosing the tub. Hydro Systems is not responsible for the cost to remove/reinstall a tub.
CARE AND CLEANING-
To assure a long lasting “like new” look on your Metro Collection bathtub we recommend the following easy
care procedures:
1)
For normal maintenance, especially after use, clean with a soft cloth or sponge and a mild soap or liquid detergent.
2)
DO NOT USE abrasives such as scouring compounds, scouring pads, steel wool or harsh chemicals on your
Hydro Systems bathtub. For deeper stains, hard scale deposits or any other cleaning or maintenance problem,
contact your Hydro Systems dealer.
SAVE THESE INSTRUCTIONS FOR LATER REFERENCE
WARNING:
This product can expose you to chemicals including styrene, which is known to the State of California to cause
cancer. For more information, go to www.P65Warnings.ca.gov.
