Page 3
www.safe-t-cover.com 1-800-245-6333
7/8/2020
11.
Repeat Steps 8, 9, & 10 on the other side of the enclosure. Note, all Inside Anchoring Brackets must be
installed for the enclosure to withstand strong winds.
12.
For maximum protection, it is suggested that the area between the bottom of the enclosure and the
concrete base should be caulked except for the “C” panels. DO NOT CAULK THE BOTTOM OF
THE “C” PANELS.
13.
Provide a ground-fault interrupter device in all electrical circuits per all applicable codes. Install the
heater(s) as per the manufacturer’s instructions and governing local and national codes.
14.
REMOVE THE PVC MASKING FILM IMMEDIATELY AFTER INSTALLATION. If the panels get
wet with the masking film in place, water will irreversibly stain the panels. Summertime heat will bake
the masking film onto the panels.
CONTENTS
1.
Assembly parts included:
A.
2- “A” (end) Panels
B.
4- “B” (side) Panels
C.
1- “C” (removable access) Panel
D.
1- “C” (removable access) Panel W/drain
E.
1- “D” (roof) Panel
F.
4- Outside Corner Anchoring Brackets (1 ½” x 1 ½”)
G.
4- Inside Anchoring Brackets (3” x 3”)
H.
4- Inside Roof Clips
I.
1- Package of Anchors
J.
1- Package of Hex Head Screws
K.
1- Masonry Bit
L.
1- Magnetic Chuck
2.
Tools needed:
A.
Hammer
B.
Screw Gun
C.
¾” Wrench
D.
Hammer Drill
