INSTRUCTIONS
CLEANING THE REFLECTOR AND LAMP
•
Unplug the reflector and allow it to cool.
•
Wearing gloves, carefully remove the lamp and set it aside.
•
Mix warm, mild soap and water and apply sparingly to the reflector’s aluminum interior with a
clean washcloth. Dry with a second washcloth. Flip reflector over to cleanse both sides.
•
Run a dry, soft washcloth over the lamp to remove dust particles, taking care not to leave any
skin oils/fingerprints on it (try to wear gloves whenever handling the lamp).
•
Install the lamp back into the socket in the reflector.
TIPS
•
The lamp may require 10‒30 minutes cooling time before restarting.
•
After you plug in and power on the ballast, the lamp may require several minutes to reach its full
brightness.
•
Be aware that in the event of a momentary power interruption, the lamp will not restart
immediately.
•
Some variation in the color of light emitted by the lamp is not unusual, especially in the first 100
hours of operation.
•
Never pull the cord to unplug the reflector; pull the plug only.
•
Avoid scratching the lamp, subjecting it to undue pressure, or getting it wet when it is hot—these
actions may cause the lamp to break.
•
In the event of lamp breakage, immediately unplug the reflector to prevent exposure to
ultraviolet energy, which may be harmful to eyes and skin.
•
Keep room temperature below 95°F, with adequate air circulation provided by oscillation fans in
the growing area.
•
Please take care to consider proximity to plants when installing your fixture. Closer proximities
will give greater intensity, but they will also reduce the effective coverage footprint.
•
Always use a heavy-duty three-pronged grounded timer, rated for at least 15 amps.
