HydroLynx Systems 50386 ALERT2 Instructions Download

Page: 3 / 4

Page 3 of 4

HydroLynx

Systems, Inc.

•

950 Riverside Pkwy #10 • West Sacramento, CA 95605-1501

Phone 916-374-1800 • Fax 916-374-1877 • Email hydro@hydrolynx.com

50386 PCB installation

Install 50386 PCB
1.1.

Secure with wingnuts.

Connect 50386 PCB cables
2.1.

Power - P2

2.2.

Ribbon connectors - P3, P4, P13, & P14.

2.3.

SDI-12 - P7

2.4.

COM1 - P8

Connect

ALERT2

PCB to 50386 COM2 with

108322 wiring harness.
3.1.

DB9 MALE (3 wires) to J6 on left

3.2.

DB9 FEMALE (3 wires) to 50386 COM2

Summary of Contents for 50386 ALERT2

Page 1: ...ate use 1 4 drill bit 4 Install bulkhead connector 5 Tighten with 6 nut driver 6 Apply ALERT2 label on top plate ALERT2 PCB assembly P N G2012 1 Mark mounting holes on plate See photo for placement Ch...

Page 2: ...le on the mounting bracket of the Ritron radio 3 Cable tie to mounting rods 4 Put right angle BNC on the radio before installing on the plate it is a tight fit ALERT2 G2012 Encoder PCB installation Us...

Page 3: ...l hydro hydrolynx com 50386 PCB installation 1 Install 50386 PCB 1 1 Secure with wingnuts 2 Connect 50386 PCB cables 2 1 Power P2 2 2 Ribbon connectors P3 P4 P13 P14 2 3 SDI 12 P7 2 4 COM1 P8 3 Connec...

Page 4: ...io Harness ALERT2 PCB 6 pin J1 to Ritron radio DB15 4 108505 Power Harness ALERT2 PCB 2 pin J7 to 50386 PCB J4 GPS antenna kit GPS antenna cable 5ft 1 Remove any cables already on the mast so they wil...

Brands by name