Page 4 of 4
HydroLynx
Systems, Inc.
•
950 Riverside Pkwy #10 • West Sacramento, CA 95605-1501
Phone 916-374-1800 • Fax 916-374-1877 • Email hydro@hydrolynx.com
Install new harnesses
1.
108503 internal GPS antenna cable
Right angle SMA connector on
ALERT2
PCB.
2.
Straight SMA connector to bulkhead SMA
connector under top plate.
3.
Install radio harness.
3.1.
108504 Maxon Radio Harness
ALERT2
PCB 6 pin J1 to Maxon radio DB9.
3.2.
108758 Ritron Radio Harness
ALERT2
PCB 6 pin J1 to Ritron radio DB15.
4.
108505 Power Harness
ALERT2
PCB 2 pin J7 to 50386 PCB J4
GPS antenna kit
GPS antenna cable 5ft.
1.
Remove any cables already on the mast so they
will not be damaged.
2.
Drill a 5/8 hole in the mast about 9" up from the
mast enclosure.
3.
Run the cables through the mast, use long nose
pliers to pull the connector through the hole.
4.
Install GPS antenna on mast with b U-bolt.
5.
The open/close bushing is split so it will go around
the coaxial cable, press the bushing in the 5/8 hole
and install the strain relief provided.
6.
Install the rest of the items in the GPS antenna kit.
