5
Hydro
Tab
Marine Engineering
Electric saw
Drill Ø4
Drill Ø8,5
Drill Ø5,5
Drill Ø3
5mm
Allen Key No 5
Screwdriver
Drilling tool
Required Tools for Installation
Sikaflex gun
Marking tool
(pencil or marker)
Before Installation
1. For high speed boats, overtrim may cause unexpectable turn. Improper use of trim tabs, may result to
accident or injury.
2. DO NOT PLACE YOUR FINGERS ON THE SIDES OF THE INTERCEPTORS (Figure 4).
Severe injury danger!!!
Safety precautions
WARNING!
2
1
3
Right
Wrong
1. For high speed boats, overtrim may cause unexpectable turn. Improper use of trim tabs, may result to
accident or injury.
2. DO NOT PLACE YOUR FINGERS ON THE SIDES OF THE INTERCEPTORS (Figure 4).
Severe injury danger!!!
Safety precautions
WARNING!
4
A good hint is that the closer the units are to the water line, the best the bank control of the boat will be
(Figure 3).
Attention!
Please make sure that the pipe
insertion hole is accessible from the engine room
(Figure 2).
Make sure there are no obstructions behind the
drilling area (tanks, fuel lines, cabling) which can
be damaged or prevent the installation (Figure 1).
If there is a double installation on the boat please
allow a 18 to 20 mm space between them (Figure
4).
