www.hydrotek.ca
ACTIVE AQUA CHILLER 1 / 10 HP
Features
• Recommended reservoir capacity (13-50 gal/50-190 L)
• Anti-corrosive pure titanium evaporator for both fresh
and salt water
• Rate of flow: 1/10 HP (70–320 GPH, 250-1200 L/hour)
• Recommended pumps: 160 or 250 GPH
• Tubing size: 1/2" (HGTB50), 3/4" (HGTB75)
(comes with 2 sets of fittings)
• Unit Dimensions: 16.5"L x 9.6"W x 14.4"H
Specifications
Shipping weight: 37.0 lbs
Package dimensions: 20.0L x 12.7W x 19.5H
Voltage: 120
Rated amperage: 2.2
Rated wattage: 190
ACTIVE AQUA CHILLER 1 / 4 HP
Features
• Large refrigeration capacity
(recommended volume 26-80 gal/100-300 L)
• Anti-corrosive pure titanium evaporator for both
fresh and salt water
• Rate of flow: 1/4 HP (264–660 GPH, 1000-2500 L/hour)
• Recommended pumps: 250 or 550 GPH
• Tubing size: 1/2" (HGTB50), 3/4" (HGTB75)
• Unit Dimensions: 17.6"L x 13"W x 17.3"H
Specifications
Shipping weight: 38.4 lbs
Package dimensions: 20.7L x 19.9W x 20.3H
Voltage: 120
Rated amperage: 4.7
Rated wattage: 460
Parts:
Chiller unit
x 1 ea.
In
fl
ow/ou low
fi
ng kit:
x 1 ea.
a. Inlet/outlet
fi
ngs
x 2 ea.
b. Worm drive hose clamps
x 2 ea.
c. Rubber replacement collars (extras)
x 2 ea.
d. Replacement fuse
x 1 ea.
Assembly
Instructions:
Remove the chiller unit and all of the contained hardware from the box and packing
material.
Set the chiller unit upright in the desired area on a stable surface ensuring there is at
least 1 of clearance around the body (sides, top, and back) of the unit.
Install the inlet/outlet
fi
ngs onto the in
fl
ow and ou low threaded sites.
SETUP AND TROUBLESHOOTING GUIDE SUMMARY
Operation:
1. Do NOT power on the chiller unit yet. Fully submerge the water pump to be used, plug it
in, and ensure that water is moving freely between the holding reservoir and the chiller unit.
2. Plug the chiller into a grounded outlet and ensure the power switch located on the back
of the unit is in the “ON” (I) posi on.
Note: If the in
fl
ow and ou low
fi
ngs are of di
ff
erent sizes, typically the larger one is used
on the in
fl
ow and the smaller one on the ou low.
4. A ach the desired length of tubing onto each in
fl
ow and ou low
fi
ng adapter with
the worm drive hose clamps. The in
fl
ow should connect the chiller to the appropriate
sized submersible water pump,
in the proper sized reservoir
see a
Ʃ
ached performance
chart
The ou low tube should hang freely in the reservoir to reintroduce the chilled
water back into the holding tank.
