hygena 203/9309, Assembly Instructions Manual

Assembly Instructions

11

Step

13

Drill these 2 holes if 

you have fitted the 

hinges to the left side.

Drill these 2 holes if you 

have fitted the hinges 

to the right side.

ONLY drill 

these 2 holes 

or

Drill the handle holes 

in the door

Important:

Please follow 

these instructions

carefully.

Lay the door       down 

onto a smooth surface.

Important: 

Carefully 

choose which holes you 

need to drill.

This will depend on 

which side you fitted the 

hinge plates     . 

Check that the holes and 

hinges are in the same 

place as the diagrams.

Using the pilot hole in 

the rear face of the door, 

.     drill through the 

holes indicated opposite, 

using a 2.5mm diameter 

drill.

Turn the door       over 

and open out the 2.5mm 

holes that you have just 

drilled by drilling back 

through them with a 

5mm drill.

Note:

 Drill bits are not 

provided.

Fit the soft close fitting 

onto the bottom hinge, 

as shown.

Push the hooks on the 

soft-close fitting into the 

holes on the hinge and 

then press down to click 

into place.

5

K

5

5

5

PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY

TO CHOOSE WHICH 2 HOLES YOU WILL NEED TO DRILL

Note:

 We recommend the 

use of a small piece of 

waste wood, placed 

behind the hole while 

drilling, to reduce the 

possibility of any breakout.

Note:

 We recommend the 

use of a small piece of 

waste wood, placed 

behind the hole while 

drilling, to reduce the 

possibility of any breakout.

DO NOT drill 

any other holes 

M

ONLY drill 

these 2 holes 

5

DO NOT drill 

any other holes 

M

M