Assembly Instructions
12
Step
14
Small piece of
waste wood
Drill the handle holes
in the door
Important:
Please follow
these instructions
carefully.
Lay the doors and
. down onto a smooth
surface.
Important:
Carefully
choose which holes you
need to drill.
This will depend on
which side or
you fitted the hinge
plates .
Check that the holes and
hinges are in the same
place as the diagrams.
Note:
We recommend
the use of a small piece
of waste wood, placed
behind the hole while
drilling, to reduce the
possibility of any
breakout.
Using the pilot hole in
the rear face of the door,
drill through the holes
indicated opposite, using
a 2.5mm diameter drill.
Turn the door over and
open out the 2.5mm
holes that you have just
drilled by drilling back
through them with a
5mm drill.
Note:
Drill bits are not
provided.
In the next step, fit the
handles using the holes
you have drilled here.
6
7
2
L
1
7
6
Important
ONLY drill the
2 holes in each
door shown
here if you
have fitted the
hinges to the
RIGHT side.
DO NOT drill
any other holes
ONLY drill
these 2 holes
Small piece of
waste wood
DO NOT drill
any other holes
ONLY drill
these 2 holes
If you have
fitted the
hinges on the
LEFT side,
go to the
previous step.
PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY
TO CHOOSE WHICH HANDLE HOLES YOU WILL NEED TO DRILL
6
7
