Page 36
There is a 3mm-wide crack between the pump drain hose jacket
and the inner surface of the housing drain connection. If water
collects in the base plate, it will flow through this crack into the
drainage system.
6.4
Water Installation Check
Go down the following water installation checklist:
Are all screws and clamps properly tightened?
Is the water supply pipe flushed?
Was the water installation correctly installed?
Can the blow-down water drain freely?
Was the water discharge correctly installed?
Is there no leakage from the water supply pipe and
water discharge?
Warning:
Flush the water supply pipe before connecting to the
solenoid valve, especially a newly installed pipe. This prevents
premature damage.
