3.2. OPTION 2: ATTACHING THE MIGHTYLITE VIA THE PIPE BRACKET
If attaching the Mightylite Pro to a pipe or post using the pipe bracket, first ensure the pole is strong enough to support the
weight of the Mightylite then proceed as follows:
• Establish the correct position for the Mightylite Pro on the pipe ensuring the wires can easily reach the unit.
• Position the pipe bracket and U bracket around the pipe and secure using appropriate nuts bolts and washers (not
provided), as shown in [Fig.5]
• Offer the Mightylite Pro up to the U bracket and secure using the securing bolts, spring washers and washers
provided [Fig.2].
• Loosen the 4 screws holding the front of the connection box in place, and remove.
• Feed the wire through the cable gland, gently tightening gland nut up against the gland body [Fig. 4] to ensure the
wire(s) is secured in place and no water can get though into the connection box.
• Wire the Mightylite Pro as described in Section 4.
4. WIRING THE FLOODLIGHT
• Once the power cable has been fed through the cable gland, approximately 6mm of insulation should be stripped
from each of the cores of AC cable ready to attach it to the terminal block in the front of the light fitting.
NOTE: The Hylite Mightylite Pro MLP120 and MLP200 are Class 1 fittings and therefore need to be Earthed
4.1 CONNECTING TO POWER SUPPLY
IMPORTANT: The Mightylite Pro has two dual channel drivers which control the 4 LED arrays within the Mightylite Pro. The four
BROWN (Live) wires in the Mightylite Pro terminal, each operate as the Live for each of the LED arrays, enabling the arrays to
be wired to be switched on and off independently of each other (See Section 4.2 Wiring Options). The two BLUE (Neutral)
wires in the terminal operate as the Neutral for each of the drivers.
The unit is supplied with all 4 wires linked into 2 terminals which are, in turn, connected by a single BROWN wire. To wire the
unit so all 4 LED arrays operate together from a single switch (Single Level wiring) proceed as follows:
• Connect the BROWN or RED (Live) wire to either terminal (marked “L”) holding 2 BROWN wires in the floodlight unit,
and linked together by a single BROWN wire [Fig.6].
• Connect the BLUE or BLACK (Neutral) wire to the terminal (marked “N”) holding the 2 BLUE wires in the floodlight unit
[Fig.6].
• Connect the YELLOW/GREEN or BARE (Earth) wire to the terminal (marked “EARTH”) holding the YELLOW/GREEN
wire in the floodlight unit
4.2 WIRING OPTIONS
Live
Neutral
Earth
Fig. 7 Wiring for Single Lighting Level
Note: One switch operates the Mightylite Pro which is always
at full power (100% light level) when switched on.
Note: One switch operates two of the Mightylite Pro LED
arrays, and another controls the other two arrays, enabling the
unit to operate at 50% or 100% power dependent on
switching.
Fig.8 Wiring for Two Lighting Levels
L1
(LIVE)
L2
(LIVE)
NEUTRAL
EARTH
