Install the brake pads. (Refer to page 2-14)
SILICONE GREASE
Apply SILICONE GREASE to the brake caliper hold-
er.
Tighten the caliper mounting bolts
.
With the hose end seated to the stopper, tighten the
union bolt
Fill the system with brake fluid and bleed air. (Refer to
page 2-16)
Inspection after reassembly : Refer to page 2-14
Front brake caliper mounting bolts
:18~28 N m (1.8~2.8 kg m)
Front brake hose union bolts
:20~25 N m (2.0~2.5 kg m)
Measure the runout using the dial gauge.
Replace the brake disc if the runout exceeds the service
limit.
If either measurement exceeds the service limit,
replace the brake disc. (Refer to page 6-3)
Dial gauge : 09900-20606
Magnetic stand : 09900-20701
Brake disc thickness
Service limit
3.0 mm (0.12 in)
Brake disc runout
Service limit
0.3 mm (0.012 in)
Micrometer (0 25 mm) : 09900-20201
BRAKE DISC INSPECTION
Check the brake disc for damage or cracks. Measure the
thickness using the micrometer.
Replace the brake disc if the thickness is less than the
service limit or if damage is found.
6-9 CHASSIS
Summary of Contents for 2002 Comet 125
