MASTER CYLINDER DISASSEMBLY
Drain brake fluid the master cylinder.
Disconnect the brake lamp switch lead wire coupler.
Remove the union bolt
.
Remove the two clamp bolts and take off the master
cylinder.
Remove the two fitting screws and separate the cap
and diaphragm.
CAUTION
Place a rag under the union bolt so that brake
fluid can not contact the parts.
Detach the dust seal boot
and remove the circlip.
Pull out the piston/cup set
and spring
.
CHASSIS 6-10
Summary of Contents for 2002 Comet 125
