Rear Cylinder
Front Cylinder
ENGINE 3-12
PISTION
Place a clean rag over the cylinder base to prevent
piston pin circlips from dropping into crankcase.
Remove the piston pin circlips with long-nose pliers.
Piston pin puller : 09910-34510
Remove the piston pin by using the special tool.
Remove the two cylinder base nuts and cylinder.
Remove the rear cylinder head and cylinder with the
same manner of the front cylinder head and cylinder
removal.
CAUTION
If tapping with the plastic hammer is necessary,
pay attention to break the fins.
NOTE
Make an identification on each piston head so
that confirmed the cylinder.
Summary of Contents for 2002 Comet 125
