Bearing installer : 09913-75820
REASSEMBLY
Drive in the oil seal using the special tool.
Install the circlip.
Service limit
0.1 mm (0.004 in)
Clutch driven plate
distortion
Thickness gauge : 09900-20806
CLUTCH DRIVEN PLATES
Measure each clutch driven plate for distortion using
the thickness gauge. If a clutch driven plate is not within
the service limit, replace the clutch plates as a set.
Standard
11.8~12.0 mm (0.465~0.472 in)
Clutch drive plate
claw width
Service limit
11.0 mm (0.433 in)
Clutch drive plate
claw width
Standard
2.9~3.1 mm (0.114~0.122 in)
Clutch drive plate
thickness
Service limit
2.6 mm (0.102 in)
Clutch drive plate
thickness
Vernier calipers : 09900-20101
CLUTCH DRIVE PLATES
Measure the thickness and claw width of the clutch drive
plates using vernier calipers. If a clutch drive plate is not
within the service limit, replace the clutch plates as a
set.
3-29 ENGINE
Summary of Contents for 2002 Comet 125
