ELECTRICAL SYSTEM 5-6
When the engine rpm become higher, the generated voltage of the AC generator also becomes higher and the
voltage between points � and � of the regulator according becomes high, and when it reaches the adjusted volt-
age of the control unit, consequently the control unit becomes “ON”condition. On the “ON”condition of the con-
trol unit, signal will be sent to the SCR (Thyristor) gate probe and SCR will become “ON”condition. Then the SCR
becomes conductive to the direction from point � to point �. Namely at the state of this, the current generated
from the AC generator gets through SCR without charging the battery and returns to the AC generator again. At the
end of this state, since the AC current generated from the AC generator flows into the point �, reverse current
tends to flow to SCR, then the circuit of SCR turns to “OFF”mode and begins to charge the battery again. Thus
these repetitions maintain charging constant voltage to the battery and protect it from overcharging.
A. C generator
Ig. switch
Controlunit
Battery
Regulator / Rectifier
LOAD
Summary of Contents for RX 125 -
