CHASSIS 6-28
AXLE SHAFT
Using a dial gauge, check the axle shaft for runout
and replace it if the runout exceeds the limit.
WHEEL RIM
Make sure that the wheel rim runout does not
exceed the service limit when checked as shown.
An excessive amount of runout is usually due to
loosen spokes or a bent wheel rim.
If properly tightening the spokes will not correct the
runout, replace the wheel rim.
SPROCKET
Inspect the sprocket teeth for wear. If they are worn
as illustrated, replace the sprocket and drive chain.
Dial gauge(1/100) : 09900-26006
Magnetic stand : 09900-20701
“V”Block : 09900-21304
Service limit 0.25 mm
Axle shaft runout
Worn or loose wheel bearings must be replaced
before attempting to true wheel rim.
CAUTION
Service limit
2.0 mm
Wheel rim runout
(Axial and Radial)
Normal wear
Excessive wear
Summary of Contents for RX 125 -
