PERIODIC MAINTENANCE 2-10
NOTE:
Inspect and Clean Every 1,000 km.
Visually inspect the drive chain for the below listed
possible abnormality. (Lift the rear wheel by plac-
ing the jack or block, and turn the rear wheel slowly
by hand, with the transmission in NEUTRAL.)
Inspect for :
1. Loose pins
2. Damaged rollers
3. Rusted links
4. Twisted or seized links
5. Excessive wear
If any defects are found, the drive chain must be
replaced.
● Wash the chain with kerosene. If the chain tends
to rust faster, the interval must be shortened.
● After washing and drying the chain, lubricate it
with chain lube or gear oil SAE # 90.
Check the drive chain for wear and adjust the
chain tension as follows.
● Loosen axle nut ① after pulling out cotter pin
and loosen the lock nut ②.
● Adjust the drive chain carefully by tightening the
adjuster ③.
CHAIN SAG
● Loosen the adjuster ③ until the chain 50~60 mm
of sag at the middle between engine and rear
sprockets.
The mark ④ on both chain adjusters must be
the same position on the scale to ensure that
the front and rear wheels are correctly aligned.
● After adjusting the drive chain, tighten the axle
nut ① securely and lock with cotter pin.
Always use a new cotter pin.
CHAIN WEAR
● Count out 21 pins on the chain and measure the
distance between 20-pitch. If the distance
exceeds 259.4 mm, the chain must be replaced.
DRIVE CHAIN
Service Limit
259.4 mm
Drive chain
20-pitch length
①
②
③
④
50~60 mm
Summary of Contents for RX 125 -
