ENGINE 3-22
VALVE AND SPRING
● Insert the valves, with their stems coated with
(HYOSUNG MOLY PASTE) all around and along
the full stem length without any break.
Similarly oil the lip of the stem seal.
● Insert valve springs, making sure that the close-
pitch end ① of each spring goes in first to rest
on the head. The coil pitch is vary: the pitch
decreases from top to bottom, as shown in the
illustration.
● Fit valve spring retainer, compress spring with a
valve spring compressor and insert cotters.
CYLINDER HEAD
● Fit dowel pins ② to cylinder head, and then
attach new gasket to cylinder head.
HYOSUNG MOLY PASTE
When inserting each valve, take care not to
damage the lip of the stem seal.
CAUTION
Use a new cylinder head gasket to prevent oil
leakage. Do not use the old gasket.
CAUTION
Valve spring compressor : 09916-14510
�
Head
①
Towards
Retainer
Lower seat
②
Summary of Contents for RX 125 -
