67
5. Reinstall the cleaned element in reverse
order of removal.
Be sure that the element is securely in
position and is properly sealed.
◉
◉
WASHING THE ELEMENT
Wash the element as follows :
1. Fill a washing pan of a proper size with
non-flammable cleaning solvent
�.
Immerse the element in the cleaning
solvent and wash it clean.
2. Squeeze the cleaning solvent out of the
washed element by pressing it between
the palms of both hands : do not twist or
wring the element or it will develop tears.
3. Immerse the element in HYOSUNG
genuine oil
�
and squeeze the oil out of
the element leaving it slightly wet with oil
.
4. Clean any dirt or debris from inside the
air cleaner case.
Be sure no dirt enters the carburetor.
Before and during the cleaning
operation, inspect the element for
tears.
A torn element must be replaced.
Be sure position the element snugly
and correctly, so that no incoming air
will bypass it.
Remember, rapid wear of piston rings
and cylinder bore is often caused by a
defective or poorly fitted element.
CAUTION
●
●
Don’t use the cleaning solvent
whose flash point is low when
cleaning the element.
●
●
Assemble the element completely
or damage severely the engine.
●
●
Be careful not to allow water to go
inside the air cleaner element.
CAUTION
●
●
When the assembly of air cleaner
element is not completely done,
dusts can go inside and damage
severely engine.
●
●
Be careful not to allow water to go
into the element while washing.
CAUTION
More frequent servicing may be
performed on ATV that are used under
severe conditions, also clean the air
cleaner element to prevent damage of
the engine.
CAUTION
A
B
Summary of Contents for TE450 -
