Hyper Tough HT19-401-003-22, Operator'S Manual

9

NOTE: Before using the tool, read the instruction book carefully.

Intended Use

The machine is intended for using with most consumer grade home and garden chemicals, such as insecticides, fungicides, 

weed killers, and fertilizers. 

BEFORE PUTTING INTO OPERATION

1. CHARGING YOUR BATTERY PACK (SEE FIG. A)

CHARGING PROCEDURES

Connect the battery charger to the power supply and the indicator light should turn to green. Then, slide the charger base on 

the battery pack to make connections and the indicator light will turn red to show that the charging has started. It will remain 

red until the battery is fully charged. When charging is completed, unplug the charger and remove the battery pack.

CHARGING INDICATOR

Light

Status

Red on  

Charging 

Green on  

Fully Charged

2. TO REMOVE THE BATTERY PACK (SEE FIG. B1)

Depress the battery pack release button firmly first and then slide the battery pack out from your tool.

3. TO INSTALL THE BATTERY PACK (SEE FIG. B2)

Slide the fully charged battery pack onto the tool with sufficient force until it clicks into position.

4. CONNECTING THE LANCE TO THE HANDLE (SEE FIG. C1-C5)

1) Insert the lance into the handle as shown. (Fig. C1)

2) Thread the cap onto the handle and tighten securely. (Fig. C1)

3) Loosen the nut (a) to extend the lance to the desired position, and tighten the nut (a) again. (Fig. C2)

4) Loosen the nut (b) to rotate the nozzle until it is aligned with the handle (pointing down), and tighten the nut (b) again. (Fig. 

C3, C4)

5) Place the assembled handle into the handle storage area. (Fig. C5)

5. ATTACHING THE HOSE (SEE FIG. D1, D2)

To attach the hose to the tank:

1) Insert the hose end into the opening on the tank as shown.

2) Slide the nut over the opening and hose end. Hand tighten. 

To attach the hose to the handle:

1) Insert the hose end into the opening on the handle.

2) Slide the nut over the opening and hose end. Hand tighten. 

Note: If there is water leakage during the initial use, the hose needs to be tightened again.

OPERATION

1. TURNING THE SPRAYER ON/OFF (SEE FIG. E)

1) To turn the sprayer on, press the On/Off button to “I” position. The red light will be illuminated.

2) To start the flow of liquid at the spray wand, depress the trigger.

3) To stop the flow of liquid at the spray wand, release the trigger.

4) To turn the sprayer off, press the On/Off button to “O” position. The red light will be off.

2. LOCK-ON (SEE FIG. F1, F2)

1) To lock-on, depress the trigger and slide it forward.

2) To release the lock-on, depress the trigger and slide it backward.

NOTE: 

Make sure the trigger is not locked on before inserting the battery pack into the sprayer.

3. FILLING THE TANK (SEE FIG. G)

1) Unscrew the measuring cup and remove it from the tank.

2) Fill the tank with the desired amount of water (up to 1 gallon).

3) Measure the recommended amount of liquid. The cap may be used for measuring up to 4 oz.

4) Carefully pour the liquid into the tank.

OPERATING INSTRUCTIONS