HySpeed HT2000LHF
Instruction Manual
3-1
6
Section 3
INSTALLATION
Installation Requirements
All installation and service of the electrical and plumbing systems must conform to national or local
electrical and plumbing codes. This work should be performed only by qualified, licensed personnel.
Direct any technical questions to the nearest Hypertherm Technical Service Department listed in the front of this
manual, or your authorized Hypertherm distributor.
Gas Requirements
All gases are provided by the customer
.
Refer to
Section 2
for specifications.
Upon Receipt
• Verify that all system components on your order have been received. Contact your supplier if any items are
missing.
• Inspect the system components for any physical damage that may have occurred during shipping. If there is
evidence of damage, refer to
Claims
. All communications regarding claims must include the model number and
serial number located on the back of the power supply.
Claims
Claims for damage during shipment
– If your unit was damaged during shipment, you must file a claim with the
carrier. Hypertherm will furnish you with a copy of the bill of lading upon request. If you need additional assistance,
call Customer Service listed in the front of this manual, or your authorized Hypertherm distributor.
Claims for defective or missing merchandise
– If any of the merchandise is defective or missing, contact your
supplier. If you need additional assistance, call Customer Service listed in the front of this manual, or your
authorized Hypertherm distributor.
Summary of Contents for HT2000LHF
