MAINTENANCE
3-6
powermax1650
Service Manual
0
WARNING
ELECTRIC SHOCK CAN KILL
•
Turn off the power and remove the input power plug from its receptacle before removing
the cover from the power supply. If the power supply is directly connected to a line
disconnect box, switch the line disconnect to OFF (O). In the U.S., use a "lock-out / tag-
out" procedure until the service or maintenance work is complete. In other countries,
follow appropriate national or local safety procedures.
•
Do not touch live electrical parts! If power is required for servicing, use extreme caution
when working near live electrical circuits. Dangerous voltages exist inside the power
supply that can cause serious injury or death.
•
Do not attempt to repair the power board or control board. Do not cut away or remove
any protective conformal coating from either board. To do so will risk a short circuit
between the AC input circuit and the output circuit and may result serious injury or
death.
HOT PARTS CAN CAUSE SEVERE BURNS
•
Allow the power supply to cool before servicing.
MOVING BLADES CAN CAUSE INJURY
•
Keep hands away from moving parts.
STATIC ELECTRICITY CAN DAMAGE CIRCUIT BOARDS
•
Put on a grounded wrist strap before handling PC boards.
Visual Inspection – Internal
1. Set the ON/OFF switch S1 to O (OFF), unplug the power cord and disconnect the gas supply.
2. Remove the cover of the power supply by removing the 18 securing screws.
3. Inspect the inside of the power supply, especially on the side with the power board. Look for broken or loose
wiring connections, burn and char marks, damaged components, etc. Repair or replace as necessary.
