Battery/TX Power Info
FCC Compliance and Advisory Statement
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for
a Class B digital device, according to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user
is encouraged to try correct the interference by one or more of the
following measures:
1. Reorient the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into and outlet on a circuit different from that
to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Any special accessories needed for compliance must be specified in the
instruction manual.
Battery Information
Contains 3.7 V, 1500 mAh
Li-ion Battery, 5.55Wh
Cannot be replaced by user
Frequency & TX Power Information
Frequency Bands: 2.4GHz
(TX Power: <2dBM )
Warning:
A shielded-type power cord is required in order to meet FCC emission limits
and also to prevent interference to the nearby radio and television reception.
It is essential that only the supplied power cord be used. Use only shielded
cables to connect I/O devices to this equipment.
CAUTION:
Any changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the
equipment.
Canada statement
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Avis Canadian
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
Cet appareil est conforme à la ou aux normes RSS non soumises aux licences
d’Industry Canada. Son utilisation est soumise aux deux conditions suivantes:
(1) cet appareil ne doit pas causer d’interférence et (2) cet appareil doit
accepter toutes les interférences, y compris celles susceptibles de provoquer le
fonctionnement accidentel de l’appareil.
IFETEL
La operación de este equipo está sujeta a las siguientes dos condiciones: (1) es
posible que este equipo o dispositivo no cause interferencia perjudicial y (2)
este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la
que pueda causar su operación no deseada.
IFETEL: RCPKIHX20-2105
IFETEL: RCPKIHX20-2106
Taiwan NCC Statement:
NCC / DGT
警語
第十二條：經型式認證合格之低功率射頻電機，非經許可，公司、商號
或使用者均不得得擅自變更頻率、加大功率或變更通原計之特性及功能。
第十四條：低功率射頻電機之使用不得影響飛航安全及干擾合法通信；
經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。
前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合
法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
