10
RIOT CONTROL USER MANUAL
Connection for your FrSky Receiver is provided via the UART 1
solder pads located in the bottom connection rows.
Connect the
SBUS OUT
wire coming from your receiver to the
RX1 (inv)
pad on the Riot Control FC. Bridge pads
B
and
SBUS
as
instructed on page 9 to enable signal inversion for UART1 (required
for S.Bus.
If you want to use FrSky Telemetry, Connect the
SmartPort
wire from your receiver to the
TX1
pad von the Riot Control FC.
Additional setup is required (see Page 21).
FRSKY RECEIVER WIRING
FrSky XSR Wiring
Summary of Contents for Riot Control
Page 1: ...Riot Control F L I G H T C O N T R O L L E R USER MANUAL...
Page 4: ...4 RIOT CONTROL USER MANUAL BOARD LAYOUT...
Page 11: ...11 RIOT CONTROL USER MANUAL FrSky R XSR Wiring Enable Inversion for FrSky...
Page 13: ...13 RIOT CONTROL USER MANUAL SPM 4649T Wiring Disable Inversion for Spektrum Serial...