S
pecificatiOnS
FAST
FAST
FAST
4,000 lb
(1,814 kg) gate
15-20 second open*
4,000 lb
(1,814 kg) gate
15-20 second open*
4,000 lb
(1,814 kg) gate
10-15 second open*
4,000 lb
(1,814 kg) gate
10-15 second open*
8,000 lb
(3,629 kg) gate
15-25 second open*
15,000 lb
(6,804 kg) gate
20-30 second open*
Single Leaf
Twin
Fast Single Leaf
Fast Twin
Fast Single Leaf
Single Leaf
Model
HydraSwing 40
HydraSwing 40 Twin
HydraSwing 40F
HydraSwing 40F Twin
HydraSwing 80F
HydraSwing 150
Duty Cycle
Continuous
Horsepower
2 hp
Drive
Hydraulic
Gate Length Max.*
up to 24 ft (7.3 m) wide
up to 16 ft (5 m) wide
each leaf
up to 16 ft (5 m) wide
up to 16 ft (5 m) wide
each leaf
up to 30 ft (9 m) wide
up to 40 ft (12 m) wide
Gate Weight Max.*
4,000 lb (1,814 kg)
4,000 lb (1,814 kg) / leaf
4,000 lb (1,814 kg)
4,000 lb (1,814 kg) / leaf
8,000 lb (3,629 kg)
15,000 lb (6,804 kg)
Open/Close Time**
Field Adjustable
15-20 seconds
15-20 seconds
10-15 seconds
10-15 seconds
15-25 seconds
20-30 seconds
Finish
Zinc plated steel chassis with stainless steel cover
3/4 inch zinc plated steel chassis with black
powder coated steel cover
Temperature Rating
-40° to 158° F (-40° to 70° C) or -10° to 158° F (-23° to 70° C) No heater necessary
1 Phase Power
208/230V 60/50 Hz
3 Phase Power
208/230V 60/50 Hz or 380/460V 60/50 Hz
Communication
RS-232, RS-485, Ethernet/fiber using optional HyNet™ Gateway accessory
User Controls
Smart Touch Controller with 70+ configurable settings. Smart Touch keypad and display or a PC using S.T.A.R.T. software.
Relays
Three configurable user relays: one
30VDC, 3A solid state and two 250VAC, 10A electromechanical; Optional Hy8Relay™ for 8 additional relay outputs
Enclosure
Type 3R, 30w x 42h x 12d inch (76w x 107h x 30.5d cm), optional NEMA 4X
Listed to UL325
Usage Class I, II, III, IV
Usage Class III, IV
Warranty
5 year
UPS Backup Power***
AC Power Supply with
HyInverter***
HydraSwing 40
with HyInverter
HydraSwing 40 Twin
with HyInverter
HydraSwing 40F
with HyInverter
HydraSwing 40F Twin
with HyInverter
HydraSwing 80F
with HyInverter
HydraSwing 150
with HyInverter
**Actual open/close time dependent on gate weight/length, percentage of open area on panel and anticipated wind speed.
***The operator’s normal duty cycle and the actual number of gate cycles available from battery depends upon gate resistance to travel, cycle length, battery size,
state of charge and health, ambient temperature, accessory power draw and frequency of gate cycles during power outage.
To enable fully automatic operation, this gate operator requires a MINIMUM of one external entrapment protection sensor to monitor potential entrapment zones in
either the open or close direction of travel. Visit
for more information on UL 325 standards and gate safety.
Copyright Notice
© Copyright 2017 by HySecurity Gate, Inc.
All rights reserved. No part of this manual may be reproduced by any means (photocopier, electronic, or mechanical), without the express written permission of HySecurity Gate,
Inc. Federal copyright law prohibits the reproduction, distribution, or public display of copyrighted materials without the express written permission of the copyright owner, unless
fair use or other exemption under copyright law applies. Additionally, HySecurity Gate, Inc. makes no representations or warranty with respect to this manual. We also reserve the
right to make changes in the products described without notice and without any obligation to notify any persons of any such revision or change.
Trademarks
SlideDriver, StrongArm, SwingRiser, StrongArm CRASH, StongArm M30, StrongArm M50, HydraLift, HydraSwing, HydraWedge SM50, HydraSupply XL, HydraSupply, HyNet,
Hy8Relay, HyInverter AC, HyCharger DC, SlideWinder, Smart Touch, S.T.A.R.T., SwingSmart DC, SlideSmart DC, StrongArmPark DC, WedgeSmart DC, Smart DC and the
HySecurity logo are trademarks or registered trademarks of HySecurity Gate, Inc.
UL and UL logo are trademarks of UL LLC and ETL is a trademark of Intertek.
Intertek provides the ETL Listed Mark.
Products called out in
Wiring HySecurity Sensors
are trademarks or registered trademarks of Miller Edge, Inc., OMRON Corporation, and Encon Electronics.
www.SecureOpeners.com | (800) 878-7829 | Sales@SecureOpeners.com
Summary of Contents for HSG80F
