Initial Setup
When you first apply power to the operator, it is locked in Menu mode
and prompts appear on the display. The gate will not move and the
controls will not function until the prompts have been answered. The
prompts include:
• Usage Class setting
•
Open Position setting (refers to the cylinder’s position when the
gate is open: Retracted or Extended)
• Three external entrapment protection SENSOR requirements.
CAUTION
Before turning the power switch to ON, be sure to replace the vent cap with the
breather cap. Refer to page <?>. Make sure all site requirements concerning
proper wiring, safety, foundation installation, and electrical power have been met.
Five buttons on the display keypad provide operational controls. Refer
to
Display and Menu Options
for more information. To answer the initial prompts, use the Previous, Next, and
Select buttons as described in the chart below:
Smart Touch Controller: Menu Mode Navigation Buttons
To change that data
appearing in the display
To navigate through the
Selections
To choose what appears on
the display
To navigate between menu
items
Press
Select
.
Two left characters blink.
Press
Next
.
Continue pressing Next to view
all selections. (Press Previous to
reverse direction.)
Press
Select
.
Blinking characters
become static.
Press
Next
or
Previous
.
Advance - press Next
Previous - press Previous
If you are unsure of the usage classification, refer to
Identifying Gate Operator Category and Usage Class
on
page 7. It explains the different usage site classifications for UL 325.
O
pen
p
OSitiOn
and
H
ydrauLic
H
OSe
S
wap
Open Position is determined by viewing the gate opening from the secure side. If the cylinder retracts to close
the gate, set the Open Position to “R.” If it extends, select “E.”
• Select
OP “R” or “E”
when prompted
•
If OP is assigned “E” for extended, and the
gate swings out, swap position of the
hydraulic hoses.
UC 2
USAGE CLASS
OP R (RETRACTED)
OPEN POSITION
Swap hoses if motor engages and gate
moves in the wrong direction
© 2018
Initial Setup
MX3636-01 Rev. D
23
Summary of Contents for HSG80F
