HySecurity HSG80F Programming And Operations Manual Download

Page: 61 / 138

Display & Menu Options

MX3636-01 Rev. D

Installer Menu

Setting Options

Menu Tasks & Explanations

STC Wire

Connections

AD 0
AC/DC GATE

0 = gate disabled
1 = AC (alternating current)
2 = DC battery-power
3 = HyInverterAC – Power Supply

Usually, power type (AC or DC) is factory
set. Select the type of power that the gate
operator uses and is appropriately wired for.

Not applicable
(N/A)

MN 0
Model Number

0 = model type unknown

1 = HydraSwing 150
2 = HydraSwing 80F
3 = HydraSwing 40 and 40 Twin
4 = HydraSwing 40F

Select the type of HydraSwing model used
at the site.

NOTE:

This menu item only appears when

you replace the STC board or reset the OT
(operator type) using S.T.A.R.T.

N/A

SP 0
SET SPEED
(or indicate Modbus
control)

0 = gate disabled

1 = No ModBus communication**
2 = 2 ft/s
3 = 3 ft/s
**

NOTE:

A setting of 1 indicates no

ModBus communication or wiring is
present. The VFD uses its factory settings
to control speed.

NOTE:

This menu item only appears on the

SlideDriver operator if it is part of the 50VF
series. It does not appear with any other
operator type.
Set the maximum speed for the gate.

CAUTION: Slow Down extended limit

ramps must be installed on the drive
rails!

N/A

UC 0
USAGE CLASS

0 = gate disabled

1 = single family dwelling
2 = multi-family
3 = industrial *
4 = guarded location *
*not serving the general public

Designates the UL 325 Usage Class (UC). The
installer sets the usage class for the operator
to function.

NOTE:

The usage class setting does not

appear on Crash products.

N/A

SH 0
GATE HANDING

0 = gate disabled

R = viewed from the secure side, the gate
moves right to open
L = viewed from the secure side, the gate
moves left to open

NOTE:

Handing only appears on slide gate

operators. On slide gates, the installer sets

the operator’s handing before the operator

will function, so an R or L appears in the
display.

N/A

OP 0
Open Position

0 = gate disabled

R = retracted.
E = extended

HydraSwing only

: The installer must identify

the cylinder’s open position before the

operator will function.
Set OP to R if the cylinder is retracted when
the gate is open.
Set OP to E if the cylinder is fully extended
when the gate is open.
Refer to the

HydraSwing Installation

Instructions

for graphical representations

N/A

BU 0
LOUDEST BUZZER

0 = buzzer not set

1 = Frequency 1 * (on)
2 = Frequency 2 * (on)
*Select the loudest buzzer

Usually, set at the factory. If menu item
appears, select either buzzer 1 or 2. Make
sure to choose the loudest audible buzzer
sound for your operator type.

N/A

FD 0 (OFF)
FACTORY DEFAULTS

0 = user settings

(custom)

1 = reload factory settings

Select setting 1 to return the operator to
factory defaults which globally restores all
menu settings back to new operator status.

NOTE:

If factory defaults are restored,

any customized menu settings will need
to be reprogrammed. You can save your
customized menu settings using a PC laptop
& S.T.A.R.T.

N/A