SAFETY INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
It is important that only qualifi ed
installers handle installation of
HySecurity Gate vehicular gate
operators.
A “qualifi ed” installer has
one of the following:
A minimum of three years experience installing
similar equipment.
Proof of attending a HySecurity Technical
Training seminar within the past three years.
Significant manufacturer endorsements of
technical aptitude in gate operator installation
and operation.
Underwriter Laboratories (UL) and the American
Society for Testing and Materials (ASTM) are
responsible for current safety standards and
regulations regarding gate operators and
automated gates. All aspects of gate installation
must comply with the appropriate safety standard.
For the most up-to-date ASTM F2200 Gate and
Fence Standards, refer to
www.astm.org
. For UL
325 Safety Standard, refer to
www.ul.com.
A moving gate or barrier arm can cause serious
injury or death. To reduce the risk of injury or
death:
1.
R E A D A N D F O L L O W A L L
I N S T R U C T I O N S . R e a d g a t e
operator’s product manual and
review all product labels and
literature prior to installing,
operating, or maintaining automatic
gate operator.
WARNING
A moving gate or barrier arm can cause serious
injury or death. Start gate operator only when
the gate's travel path is clear.
2.
Never let children operate or play with gate
controls. Keep all remote controls, especially
radio transmitters, away from children. Do not
allow children to play on or around gate or
gate operators.
3.
Always keep people and
objects away from gate. NO
ONE SHOULD CROSS THE
PATH OF THE MOVING GATE.
Start gate operator only when a
gate’s travel path is clear.
4.
Test gate operator monthly. Gate MUST
reverse on contact with a rigid object or stop
when an object activates non-contact sensors.
After adjusting force or limit of travel, retest
gate operator. Perform routine tests of
entrapment protection sensors, such as photo
eyes and gate edges. Failure to adjust and
retest gate operator properly can increase risk
of injury or death.
5.
KEEP GATES PROPERLY
MAINTAINED. Read product
manuals. Have a qualified
service person make repairs
to gate hardware. Replace
batteries in accessory or
entrapment sensory devices.
6.
Use emergency release only when gate is not
moving.
7.
Automated gate entry is for vehicle use only.
Pedestrians must use a separate entrance.
Make sure a separate walk-through entrance
is nearby. Make certain a clear pedestrian path
is designated and signs direct pedestrians to
walk-through gate. No one should cross path
of a moving gate.
8.
SAVE THESE INSTRUCTIONS.
10
| www.hysecurity.com
SWINGSMART DC PROGRAMMING AND OPERATIONS MANUAL
MX3640-01 REV. D ©2018
