GENERAL MAINTENANCE
To install the two new batteries, reverse the
removal procedure. See Figure 64
1.
Connect the red wire to the red terminal on
left battery and slide the battery onto the tray
and move it behind the motor.
2.
Connect the blue wire between the left and
right batteries (black and red terminals).
3.
As you slide the battery onto the tray, connect
the black wire to the black terminal on the
right battery.
4.
Return the support tray to its original position
and secure it properly.
5.
Turn the AC and DC disconnect switches ON
and replace the covers.
Figure 64. Drive Belt Tension and Alignment
Remove batteries.
Disconnect wires.
Reconnect the wires onto the replacement batteries.
107
| www.hysecurity.com
SWINGSMART DC PROGRAMMING AND OPERATIONS MANUAL
MX3640-01 REV. D ©2018
