Page 4
D0324 Rev D
SwingSmart DC Quick Start Steps
© 2013 www.hysecurity.com
i
nStall
the
g
ate
a
rm
The universal elbow on the swing arm lets you easily change the handing from a left-arm configuration
to a right swing arm configuration. The illustration present below show a right hand configuration.
For more detailed steps, refer to the
SwingSmart DC Installation and Reference Manual
.
a
ttaCh
Warning S
ignS
WARNING
Be sure to place the WARNING
signs on the gate. For your
records, take a photograph of the completed
installation site.
P
OSitiOn
the
l
inkage
a
rmS
Use tapped holes and hex
bolts to hold linkage arms
in place (2x) while setting
the limit switches.
Mount bracket approximately 25 inches
(63cm) from base of operator.
Set screw
(used to prevent locking
of the elbow joint)
CAUTION
Use the supplied set screw to
prevent the arm from locking.
The intent of the offset is that, upon gate strike,
the elbow will bend and the taper clamp will slip,
minimizing damage to the gearbox and operator.
a
djuSt
the
l
imit
S
WitCheS
Extend the taper handle and loosen the taper
clamp.
Manually swing the gate to full OPEN and
CLOSE positions.
Loosen the two Phillips-head screws.
Move the limit cams so they trip the
appropriate limit switch at the full OPEN
and CLOSE positions.
Retighten the two screws.
Limit plate
Limit cam
Phillips-head
screws
Limit switches
Taper handle
Taper clamp
Over-
extension stop
Lock nut
NOTE:
If the pivot bolt is not vertical,
binding of the arm assembly may occur
during the operation.
Also, the excess on the over-extension stop
must be sawn off to accommodate for the
elbow joint covers.
Elbow
joint
