HySecurity UL 325-2016, Quick Start - Supplemental Instructions

W

HAT

THE

 I

NSTALLER

 N

EEDS

TO

 D

O

NOTE:

ØLL(Y3ECURITYGATEOPERATORSINDICATINGAMANUFACTURINGDATEOFINTHESERIALNUMBERWILLHAVETHE"UILD9EARSETTO

Ø"UILD9EAROF "9INDICATESTHATYOURGATEOPERATORISPREPAREDTOMONITORFOREXTERNALENTRAPMENTPROTECTIONSENSORS4HE"UILD
9EARSETTINGAPPEARSINTHESYSTEMSCROLLONTHEGATEOPERATORDISPLAY

The gate operator will not automatically cycle the gate 

unless an indication that the appropriate number of external entrapment protection sensors are connected and operational. 

The normally closed (NC) entrapment protection sensors wired to the Controller's SENSOR inputs are monitored using 

(Y3ECURITYŸSOFTWAREŸ0ROMPTSŸAPPEARŸINŸTHEŸDISPLAYŸREQUESTINGŸSPECIÚCŸCONÚGURATIONSŸBASEDŸONŸTHEŸGATEŸOPERATORŸTYPEŸ

4ABLEŸŸILLUSTRATESŸWHATŸOPTIONSŸAREŸAVAILABLEŸFORŸTHEŸ(Y3ECURITYŸ#ONTROLLERfSŸCONÚGURABLEŸINPUTSŸ7HATŸUSEDŸTOŸBEŸINPUTSŸ

labeled: Edge, Photo Eye Open, Photo Eye Close, and Edge COM now become: 

SENSOR 1  

SENSOR 2 

SENSOR 3 

SENSOR COM

1

Assess Your Gate Site.

Design your gate installation so entrapment zones are kept to 

a minimum, and then install your HySecurity gate operator. 

2

Install NC sensors.

Install contact and non-contact 

sensors (edge sensors and photo 

eyes) for all entrapment zones. HySecurity gates monitor normally  

closed (NC) sensors. Wire your NC sensors to SENSOR input terminals (SENSOR 1, 

SENSOR 2, or SENSOR 3) on the Smart Touch or Smart DC Controllers.

CAUTION

ØLLEXTERNALENTRAPMENTPROTECTIONSENSORSMUSTBEWIREDTOTHE3%.3/2#/-TERMINALFORPOWERANDMONITORING
PURPOSES4HETHREE3%.3/2INPUTSAREINTERCHANGEABLEANDCONÞGURABLE&OREXAMPLEITDOESNTMATTERWHETHER
YOUWIREANORMALLYCLOSEDPHOTOEYESENSOROREDGESENSORTOTHE3%.3/2ORINPUT(OWEVERDUETO
MONITORINGREQUIREMENTSEACH3%.3/2INPUT ANDCANONLYACCEPTONE.#SENSOROUTPUTCONNECTION

0HOTOEYETHRUBEAM

protecting Trailing End 

 %9%/0%.

Photo eye thru beam 

PROTECTING,EADING%ND

 %9%#,/3%

Draw-in zone  

%DGESENSOR PROTECTINGOPENDIRECTION

 %$'%/0%.

NOTE:

 When installing wired edge sensors, the wired edge must be connected to an interface module 

WITHAN.#OUTPUT3EE4ABLEONPAGE&ORWIRELESSEDGESENSORSNOINTERFACEMODULEISREQUIRED

Wireless edge sensors need the wireless gate links which include a transmitter and receiver.

8

  D0726 Rev. C 

UL 325 - 2016 HySecurity Monitored Sensors 

©

 2016  www.hysecurity.com