Before starting operational checkout, talk to the oper-
ator and check Diagnostic Trouble Codes (DTC) us-
ing the Display Panel (DP). See Troubleshooting
Guidelines and Procedures. All DTCs must be correc-
ted or cleared before starting this checkout.
No special tools or gauges are needed. Always start
sequence from left to right. Before doing check, read
each check completely.
At the end of each check, a question is asked:
•
If the answer indicates the check is OK, you
will be instructed to go to next check.
•
If the answer indicates that the check is not
OK, you will be given a required SRM repair or
be linked to the test to perform.
When a problem is found, stop operational checkout
and correct it before going to the next check. Repeat
check after repair to confirm repair was successful be-
fore proceeding with the remaining checks.
CHECK
PROCEDURE
ACTION
Key Icon Illumina-
ted
Turn Keyless Start Switch or Key Switch to
ON
posi-
tion with park brake applied.
Does the Key Icon appear on the Display and
remain illuminated?
YES:
Shut key
OFF
. Wait 30
seconds for power cycling
then turn key
ON
. Key icon
should not stay lit.
NO:
Display power is OK. Go
to next step.
Wrench Icon Illumi-
nated
Turn Keyless Start Switch or Key Switch to
ON
posi-
tion with park brake applied.
Does the Wrench Icon appear on the Display
and remain illuminated?
YES:
Reinstall newest ver-
sion of software. See
User
Interface Supervisor
2200SRM1335 or
User Inter-
face Service Technician
2200SRM1336.
NO:
Display power is OK. Go
to next step.
Display Panel (DP)
Check
1.
Turn key or keyless switch to
ON
position.
2.
Are any DTCs displayed?
YES:
tem, General Maintenance
and Diagnostic Data, Diag-
nostic Trouble Codes, Page
9030-03-6.
NO:
DTCs are OK. Go to
next check.
Operational Checkout
Operational Diagnostic Procedures
Check the Service Manual section in Hypass Online for possible updates and check pertinent Grams
9010-05-2
Confidential/Proprietary - Do Not Copy or Duplicate
Summary of Contents for A099
Page 1: ...Hyster A276 J45XN J50XN J60XN J70XN Forklift...
Page 14: ...9010 2...
Page 28: ...NOTES 9010 05 14...
Page 30: ...9025 2...
